Homemade Bolt Cutter Rivet Crusher
PLANS:
None. For all tools with plans, click here.
BUILDER:
CatCow on garagejournal.com
DESCRIPTION:
Homemade Harbor Freight bolt cutter ground down to function as a rivet crusher. Made specifically for the rivets on an AK-47 receiver.
RATING:
(3)
Feb 03, 2018 1:28 PM
straightshooter
did anyone get back on this feed on how to make one of these bolt rivet cutters?
May 21, 2016 10:03 PM
TomZ124cc
I would like to make one of these for my 74 build. I was wondering if you could provide some dimensions to cut this "Chinook Salmon Jaw" ?It appears that you have removed about a 1/4" from the cutting edge of the jaws and then squared up the hook portion, about 3/8" X 1/2" long and beveled slightly. How much was removed from the top to allow it to get inside the Trunnion?
Rate this build:
CATEGORIES:
TAGS:
Newest Forum Posts
- Ostrich egg collection trick - GIF by ToolTalkBot on 2024-12-18 10:27:01
- Steering wheel emblem removal tip - GIF by nova_robotics on 2024-12-18 10:05:59
- Demolishing the top of a tower - GIF by astroscuba on 2024-12-18 09:03:41
- Vinyl flooring corner technique - GIF by wood_1 on 2024-12-18 08:44:32
- How girls carry heavy trees - GIF by albertq on 2024-12-18 08:28:56
- Covering buttons with fabric - GIF by ToolTalkBot on 2024-12-18 08:14:02
- shopmade rotary Broach by metric_taper on 2024-12-18 07:15:02
- Concrete staircase cutting saw - GIF by ToolTalkBot on 2024-12-18 06:07:01
- Billboard falls into traffic in Mexico - GIF by Gadgeteer on 2024-12-17 23:02:29
- Pulling a stump into a pickup truck bed - GIF by ToolTalkBot on 2024-12-17 21:51:02
DIY Bolt Cutter Rivet Crusher - comment on how to build a Bolt Cutter Rivet Crusher - 3 comments
straightshooter says:
Feb 03, 2018 1:28 PM
did anyone get back on this feed on how to make one of these bolt rivet cutters?
TomZ124cc says:
May 21, 2016 10:03 PM
I would like to make one of these for my 74 build. I was wondering if you could provide some dimensions to cut this "Chinook Salmon Jaw" ?It appears that you have removed about a 1/4" from the cutting edge of the jaws and then squared up the hook portion, about 3/8" X 1/2" long and beveled slightly. How much was removed from the top to allow it to get inside the Trunnion?
Related Homemade Tools:
Signup for our newsletter and get the 186 More Best Homemade Tools eBook free!
- BuildThreads Network:
- HomeMadeTools.net
- BikeBuilds.net
- FordBuilds.net
- ChevyBuilds.net
- 4x4Builds.net
- BoatBuilds.net
- PlaneBuilds.net
- CabinBuilds.net
- GarageBuilds.net
- MuscleCarBuilds.net
- HotRodBuilds.net
- GMBuilds.net
- TruckBuilds.net