Homemade Table Saw Fence Extension
PLANS:
None. For all tools with plans, click here.
BUILDER:
Philip Houck on finewoodworking.com
DESCRIPTION:
Homemade table saw rip fence extension intended to support full plywood sheets.
RATING:
(0)
Apr 27, 2020 1:07 PM
Anonymous
Absolutely essential! Without this, it's extremely difficult to guide a full 8x4' sheet onto a tablesaw without it wobbling against the rip fence. Because panels are usually guided by hand along beside a rip fence, wobble of the panel can cause unrecoverable drift and gouges in the cut that throw accuracy off by as much as 1/8" or more. This is undesirable. The fence extension solves this problem by providing a longer surface area for the edge of the plywood to push against. This hold the sheet more stable while you make the cut. It's very necessary improvement for accuracy of the cut.
Rate this build:
CATEGORIES:
LEVEL OF DETAIL (1-5):
2
Newest Forum Posts
- Machining spiral spindles - GIF by ToolTalkBot on 2025-01-17 21:51:01
- Using a magnet to remove scrap from a railroad track - GIF by Elizabeth Greene on 2025-01-17 20:48:38
- Making a coin bracelet - GIF by ToolTalkBot on 2025-01-17 20:27:01
- Making an ice boat - GIF by that_other_guy on 2025-01-17 19:49:13
- Roots burst through PVC pipe - GIF by that_other_guy on 2025-01-17 19:36:11
- Revolving restaurant buffet in Taiwan - GIF by that_other_guy on 2025-01-17 19:33:28
- Tamp shoeing asphalt - GIF by that_other_guy on 2025-01-17 19:26:20
- An excavator held up by a crane - GIF by that_other_guy on 2025-01-17 19:24:36
- Puppet filming behind the scenes - GIF by that_other_guy on 2025-01-17 19:22:38
- Mining coal - GIF by that_other_guy on 2025-01-17 19:19:02
DIY Table Saw Fence Extension - comment on how to build a Table Saw Fence Extension - 1 comments
Anonymous says:
Apr 27, 2020 1:07 PM
Absolutely essential! Without this, it's extremely difficult to guide a full 8x4' sheet onto a tablesaw without it wobbling against the rip fence. Because panels are usually guided by hand along beside a rip fence, wobble of the panel can cause unrecoverable drift and gouges in the cut that throw accuracy off by as much as 1/8" or more. This is undesirable. The fence extension solves this problem by providing a longer surface area for the edge of the plywood to push against. This hold the sheet more stable while you make the cut. It's very necessary improvement for accuracy of the cut.
Related Homemade Tools:
Signup for our newsletter and get the 186 More Best Homemade Tools eBook free!
- BuildThreads Network:
- HomeMadeTools.net
- BikeBuilds.net
- FordBuilds.net
- ChevyBuilds.net
- 4x4Builds.net
- BoatBuilds.net
- PlaneBuilds.net
- CabinBuilds.net
- GarageBuilds.net
- MuscleCarBuilds.net
- HotRodBuilds.net
- GMBuilds.net
- TruckBuilds.net